ASSEMBLY INSTRUCTIONS
FOR
P-500 & P-600 SERIES COMPONENT PONDS

Our P-500 & P-600 series liners are built as matching components and require assembly before installation. One "assembly kit" should be purchased from Waterscape Designs, Inc. for each joint.

• Fiberglass components should be thoroughly rinsed with water to remove any mold release residue from the manufacturing process.
• Place matching components upside down on a flat, level surface (driveway, patio, flat lawn, etc.) and align flanges using 3 to 4 “C” clamps.
• When flanges have been aligned, drill 11/32” holes through both flanges at approximately 6-8” centers.
• Install 1"x5/16” stainless steel hex bolts, with stainless steel washers and nuts in holes. Do not fully tighten at this time.
• With those bolts loose, remove clamps and spread flange/joint apart 1/4" - 3/8”
• At this time, force a thick layer of silicone sealer into this joint using a cartridge & gun.
• Once the joint has been filled with silicone, all bolts can bc tightened in sequence to water proof the seal and mate the components.
• Turn the pond unit over and fill the remaining joint/gap with silicone and smooth surface to blend.
• The silicone should cure for 48 hours before being exposed to water. The pond is now ready to be installed in the ground.

®

Waterscape Designs, Inc. . 1088 W. 9th St. . Upland, CA 91786 . (909) 981-1731 . (Lic. #824893)