Tetra Liner Patching Tape

• Locate the leak and allow the area to dry (see Note). The surface of the patching tape and the surface of liner must be clean.
• Prepare the damaged surface by wiping with an oil-free solvent such as mineral spirits.
  Avoid soap, oil or other products that could leave a film. Make certain the cleaned area is wider than the patching tape. Allow the surface to dry.
• Unroll and carefully position the Tetra Patching Tape along the length of the damaged
  area. The hole or tear should be centered under the tape.
• Apply even pressure to make a tight waterproof bond. Your liner is now ready for water.

Note: Leaks can be difficult to find. One method is to allow the water level to fall to the level of the leak. Locate the leak, lower the water level further, and then mend.

Note: Tetra Patching Tape should only be used on EPDM fish Safe liner.

®

Waterscape Designs, Inc. . 1088 W. 9th St. . Upland, CA 91786 . (909) 981-1731 . (Lic. #824893)